custom uniforms

Work Uniform Care

Working blue shirts and sew-on devices:

It is a good idea to wash your work shirts along with new name tapes before you sew on the name. In other words, if you get a new shirt and new name tape, throw both into the washer/dryer a few times before you actually get the tapes affixed to the shirt. The reason for this is that the shirt and tape may not wear the same way, and you might end up with a name tape that makes the shirt all wrinkly around the edges. A CG Petty Officer recommended this, and suggested the wash process be done at least 3-4 times before you go sewing on the tapes.

Devices: Name tags and certain devices can be prevented from "flopping" by using a backing. Vanguard makes (and exchanges carry) backing material, which you wear inside the shirt, cut to the device size. As an alternative, use thin cardboard or plastic, such as that from a margarine container lid. The auxiliary manual contains instructions on where on the uniform they should be positioned. If you have any questions about proper placement, just ask!

Covers: Hats, or covers, are to be worn squarely on the head, not tilted back or to the side. Hair or bangs should not be visible below the brim or hatline of the cover. Long hair should be up and away from the collar and contained under the hat, not sticking out the back. Covers should always be worn outdoors, and removed indoors.

Work Shirts: -- Putting creases in your shirts

For the front of the work shirt, use the pocket flap buttons as a guide for where to place the crease, and have the crease run parallel to the buttons down the work shirt from the collar to the tails/bottom. Thus, you will end up with 2 creases down the front of the shirt.

For the back of the work shirt, find the center of the shirt, and crease from about 2 inches below the collar to the bottom. Take a dollar bill and place it spread out lengthwise to each side to find the side creases. These creases will begin about an inch lower than the primary crease and go to the bottom. Thus you will end up with three back creases.

Don't forget to press the sleeves!

Shoes/Boots: Keep your black shoes shiny! Total investment under 5 bucks. Here's how:

The Exchanges should have a few things you need: Polish, a Shoe brush, a rag, and of course, your shoes (they're not included in the price quote).

Read the directions on whatever black polish you pick. If they differ, follow their directions, not mine. Basically, you apply a thicker layer first, allow it to dry for a few minutes, then brush that layer to create the base. Not much shine will appear after this layer. Then, you apply a thin layer, you don't need to let it dry. By gently sprinkling water on the new layer, then buffing it with a soft cloth, you will begin to develop a nice shine. You can repeat a few times if necessary. The only caveat in this process is, if you go too crazy with the buffing, you'll actually overbuff your shoes, lose the shine, and have to start over.

Belt and Buckle: The belt should be cut such that there is not a long "tail" left over. In fact, the silver end of the web belt should just slide through your buckle enough so that it appears an uninterrupted chunk of silver at the buckle.

Don't be afraid to ask questions about proper uniform. The only dumb questions about uniforms are the ones that don't get asked!